ERICO IJS100 Insulated Joint Slotter - Manual (Page 10)

Cutting tool resting
on the rail
9. Turn the worm drive shaft counter-clockwise to move the cutting tool from the gauge side of the rail to
the field side. The gear rack should continue to the end of cut position (Figure 24). Care should
be taken that the rack gently reaches its end of travel position, as the drill will twist abruptly.
Figure 23: Cutting tool ready to cut
10. Repeat Steps 6 through 9 until the insulated joint is adequately cleaned.
11. To check the depth and the quality of the cut, the operator can remove the gearbox by
performing Step 2. Perform Step 5 to install the gearbox back into the base. Proceed
to follow Steps 6 through 9.
12. Once completed, loosen the adjustable clamping pads with a 15/16” hex socket and lift
the device off of the rail.
Figure 24: Position of the gear rack at the end of cut
TECHNICAL SUPPORT:
www.erico.com IP8240_B
INSTRUCTION SHEET
10 OF 10
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
© 2012 ERICO International Corporation.