ERICO IJS100 Insulated Joint Slotter - Manual (Page 8)

Figure 19: Turn the height adjustment knob clockwise to lower the gearbox
Figure 20: Half turn counterclockwise to lift the cutting tool off the rail
5. Install the gearbox into the base assembly.
a. Lower the gearbox into the base assembly until the height adjustment screw engages the
brass nut in the base (Figure 18).
b. Hand turn the height adjustment knob clockwise until the cutting tool is resting on the head
of the rail (Figure 19).
Figure 18: Lower the gearbox into the base assembly
6. Hand turn the height adjustment knob counter-clockwise a half turn to lift the cutting tool off the
head of the rail (Figure 20) in preparation for moving the gear rack.
TECHNICAL SUPPORT:
www.erico.com IP8240_B
INSTRUCTION SHEET
8 OF 10
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
© 2012 ERICO International Corporation.