ETC Congo Family v6.4.0 - Manual (Page 89)

87
Troubleshooting - Lights Are Not Responding
If you have lights (dimmers, devices) connected and they are not
responding check this list.
• Have you reset the console properly? See
Reset the system .
• Is the device powered properly?
• Is the device set to receive the protocol you have set the board to transmit?
• Is the device receiving a signal from the console?
• Is the device set to the right channel address?
• Is there a light source connected to the device?
• Is it a lamp failure?
• Is the device circuit breaker thrown?
If nothing works you may want to use a DMX tester to check that there is DMX at the
receiving devices.