ETC Desire Series v1.6.0 User Manual - Manual (Page 44)

38 Desire Series v1.6.0 User Manual
Installing Accessories
The accessory holder is equipped with a spring-loaded retaining clip that prevents secondary
lenses and accessories from falling out.
Figure-2.8 Retaining Clip in the Locked Position.
Step 1: Release the retaining clip by pushing it sideways while gently pushing it towards
the back of the fixture.
Step 2: Insert the accessory or secondary lens in either of the two slots.
Step 3: Lock the retaining clip by pushing forward and sliding left as viewing the fixture
shown in Figure-2.8 .
W A R N I N G : Make sure all accessories are locked into position with the retaining clip
before hanging the fixture.
N o t e : For D40 and D40XT, use only secondary lenses or accessories with a 7.5 inch
mounting flange.
1
2