ETC Source Four XT HID Zoom Installation Instructions - Manual (Page 2)

2.5 inch
(64mm)
2.7 inch
(68mm)
2.5 inch
(64mm)
2.7 inch
(68mm)
1.7 inch (43mm)
5.2 inch
(132mm)
10.4 inch
(264mm)
0.53 inch (13mm)
diameter hole
0.40 inch x 0.90 inch
(10mm x 23mm)
curved slot
0.40 inch x 0.90 inch
(10mm x 23mm)
curved slot
NOTE: If printing this template from a PDF, it is important that you check the
dimensions to ensure the template is accurate.
15-30
25-50
11.1 inch
(282mm)
9.25 inch
(235mm)
Front view Side view
24.42 inch
(620mm)
13.11 inch
(333mm)
Rear view
10.4 inch
(264mm)
7.5 inch
(191mm)
13.0 inch
(330mm)
11.1 inch
(282mm)
9.25 inch
(235mm)
Front view Side view
30.86 inch
(784mm)
13.11 inch
(333mm)
Rear view
10.4 inch
(264mm)
7.5 inch
(191mm)
13.0 inch
(330mm)
Fixture Dimensions
Mounting Template
Page 2 of 2
15.75 inch
(400mm)
14.75 inch
(375mm)
7.25 inch
(184mm)
4.1 inch
(104mm)
10.25 inch
(260mm)
4.25 inch
(108mm)
(inside)
25.0 inch
(635mm)
5.0 inch
(127mm)
4.1 inch
(104mm)
4.25 inch
(108mm)
(inside)
3.2 inch
(81mm)
20.25 inch
(514mm)
10.8 inch
(274mm)
8.0 inch
(203mm)
13.0 inch
(330mm)
6.25 inch
(159mm)
Optional Mounting Adapters
Long Yoke
The mounting bolt pattern is the same as the standard yoke.
Single Pole Mount
Twin Fixture Pole Top Mount
Wall or Square Pole Mount
NOTE: For ground mounting, use the full-sized template
shown here or download the template at www.etcconnect.com.
Use application appropriate bolts, nuts, and washers such as
hot-dipped zinc or stainless steel for wet locations.
Use only the center hole in the yoke if frequent aiming adjust-
ments are needed. Use all three holes when the location is
fixed. The curved holes allow small aiming adjustments.