ETC Source Four Revolution with Wybron - Manual (Page 46)

42 Source Four Revolution User Manual
Troubleshooting
LED Indicators
The easiest way to find out the status of your Source Four Revolution fixture is to look at
the LED indicators on the upper enclosure. These LEDs are located on the top of the upper
enclosure when the fixture is sitting on its base. When the fixture is hung on a pipe, the
LEDs are visible to technicians standing below the fixture.
Green Amber Red
Off No Power Lamp OK
Calibration
Successful
On
Receiving DMX
Signal
a b
a) Green and amber blinking together indicates that there is potential software corruption.
Recycle power. If this indication persists, contact ETC customer service.
b) Red and green blinking together indicates that the thumbwheel address is set higher
than 481. Reset thumbwheel to 481 or lower. See Connections and Addressing, page
8 for further information.
Lamp Out
Calibration in
Progress
- or -
Error
Blinking
(1/second)
Not Receiving
DMX Signal
Fast Blinking
(5/second)
Self-Test Mode
LED Location
Green
Red
Amber