ETC Source Four Fresnel - Manual (Page 14)

10 Source Four Fresnel User Manual
Replacing the Lens
Replace the lens if it becomes cracked or badly scratched.
Removing the lens
Step 1: Place the fixture on a flat, stable work surface. Do Not remove or install the lens with
fixture hanging.
Step 2: Tilt the front of the fixture down at least 45°.
Step 3: Use a flat-blade screwdriver to slide the two plastic lens retaining clips on each side of
the lens outward to release the lens.
Figure-10 Lens retaining clip.
Step 4: Allow the top of the lens to drop forward from under the clips while using your hand to
prevent the lens from falling.
C A U T I O N : Never operate the fixture without a lens in place.
W A R N I N G : Unplug the fixture and allow it to cool down before attempting to change a
lens.