ETC Source Four CE Mini - Manual (Page 10)

7
Replacing the Lamp
WARNING: Allow the lamp housing to cool before replacing the lamp.
C A U T I O N : RISK OF FIRE - Use an MR16 lamp rated at 50 Watts or less.
C A U T I O N : DRY LOCATIONS ONLY.
N o t e : It is recommended to use an MR16 lamp with a nominal beam
angle of 38 degrees.
Step 1: Disconnect power to the Source Four Mini before installing the lamp.
Step 2: Loosen the brass lamp housing knob on the back of the lamp housing. The
knob is not captured so it may come loose from the luminaire.
Step 3: Pull the lamp housing away from the luminaire body.
Step 4: Pull on the lamp carefully to remove it from the lamp housing.
Step 5: Gently push down on the
replacement lamp until it is seated in
place.
Step 6: Re-align the housing into the grooves
of the luminaire.
Step 7: Align the knob with the hole, and
tighten the lamp housing knob.
Lamp housing
Lamp housing
knob