ETC Source Four LED CYC - Manual (Page 2)

E T C I n s t a l l G u i d e
Source Four LED CYC
Source Four LED CYC Page 2 of 2 Electronic Theatre Controls, Inc.
Installing the Source Four LED CYC Adapter
Step 1: Align the threading on the CYC adapter with the light engine.
Step 2: Retighten the small screw.
Step 3: Rotate the CYC adapter, squaring it to the fixture and locking it in place.
Step 4: Retighten the barrel screw.
Cleaning
Using a soft cotton or micro fiber cloth, and a 50/50 mix of water and isopropyl alcohol, gently wipe the
Source Four LED CYC components clean.
N o t e : The screws provide a tension mounting of the CYC adapter and should not be over
tightened.
C A U T I O N : Do not use paper towel as it may cause scratching.
CYC lens
Step 2
Step 3
Step 1
Step 4
When installing the CYC
adapter in this orientation, you
will need to swap the screw
positions. The barrel screw is
too large to be reinstalled
behind the vertical portion of
the CYC adapter.
Small
screw
Barrel
screw
Barrel
screw
Small
screw
The CYC adapter can be locked into either of the
positions shown here.