ETC Source Four LED v1.6.0 Quick Guide - Manual (Page 2)

E T C S o u r c e F o u r L E D Q u i c k G u i d e
Install
Source Four LED Profile Page 2 of 8 Electronic Theatre Controls, Inc.
Install
Lens Tube
Step 1: Slide the lens tube into the shutter barrel.
Step 2: Tighten the lens zoom knob.
Step 3: Tighten the Phillips screw at the top of the lens barrel.
Install Fixture
Step 1: Hang or mount the fixture.
Step 2: Attach a safety cable.
Step 3: Insert additional accessories such as a top hat, etc.
W A R N I N G : Use only hardware rated for total weight of fixture and accessories.
A safety cable (or other approved safety device) must be securely attached
to the safety cable loop before loosening the clamp.
Disconnect the unit from power and DMX and allow the fixture to cool before
removing or installing the shutter barrel or other adapters, and all cleaning
and maintenance.
Low clearance position
General use position