Flint & Walling CSM, CVSM Two-Tank Water Softeners - Manual (Page 7)

7
remier remier
roducts roducts
P P
P P
WATER TREATMENT
®
Automatic Water Conditioners
Premier Products Water Treatment | 95 North Oak St. | Kendallville, IN 46755 | 800-545-2206 | flintandwalling.com
Copyright © 2011 Flint & Walling All Rights Reserved.
Setting Hardness, Day Override and Regeneration Time
STEP 1I: Press NEXT and  simultaneously for 3 seconds.
STEP 2I - Hardness: Set the amount of hardness in grains of hardness as calcium
carbonate per gallon using the  or  buttons. The default is 20 with value
ranges from 1 to 150 in 1 grain increments. Note: The grains per gallon can be
increased if soluble iron needs to be reduced. Press NEXT to go to step 3I.
STEP 3I - Day Override: Set Day Override using  or  buttons. Factory set to
“off” for all units except CST45. Factory set to “3” for CST45. Press NEXT to go
to Step 4I.
STEP 4I - Next Regeneration Time (hour): Set the hour of day for regeneration
using  or  buttons. AM/PM toggles after 12. The default time is 2:00 a.m.
Press NEXT to go to step 5I. Press REGEN to return to previous step.
STEP 5I - Next Regeneration Time (minutes): Set the minutes of day for
regeneration using  or  buttons. Press NEXT to exit Installer Display
Settings. Press REGEN to return to previous step.
Regeneration Mode
Typically, a system is set to regenerate at a time of lower water usage. An
example of a time with lower water usage is when a household is asleep. If
there is a demand for water when the system is regenerating, untreated water
will be used.
When the system begins to regenerate, the display
will change to include information about the
step of the regeneration process and the time
remaining for that step to be completed. The
system runs through the steps automatically and
will reset itself to provide treated water when the regeneration has been
completed.
RETURN TO
NORMAL MODE
STEP 1I
STEP 2I
STEP 3I
STEP 4I
STEP 5I
IL1070
Manual Regeneration
Sometimes there is a need to regenerate the system
sooner than when the system calls for it, usually
referred to as manual regeneration. There may be a
period of heavy water usage because of guests or a
heavy laundry day.
REGEN TODAY will
Flash if a regeneration
is expected “Tonight.”
IL1071
To initiate a manual regeneration at the present
delayed regeneration time, press and release REGEN .
The words “REGEN TODAY” will flash on the display to
indicate that the system will regenerate at the present
delayed regeneration time. If you pressed the REGEN
button in error, pressing the button again will cancel
the request.
To initiate a manual regeneration immediately, press
and hold the REGEN button for three seconds. The
system will begin to regenerate immediately. The
request cannot be cancelled.
You can manually step through the cycles by pressing
the REGEN button.
NOTE: Program Timer “Lockout” Feature
The Program Timer is initially set to allow access to all
Programming, Diagnostic and History screens.
The Installer can limit access to (lockout) most screens
by activating the Lockout Feature.
Activating “Lockout” allows the user to view and
change only Water Hardness, Days Override, Time of
Regeneration and Time of Day.
Activate “Lockout” Feature: Press  then NEXT
then then SET CLOCK in sequence. LOC will briefly
appear in the display.
De-activate “Lockout” Feature: Press  then NEXT
then  then SET CLOCK . UNLOC will briefly appear
in the display.
IL1073