GAM SX4 LOOP TRAY TS6100 - Manual (Page 2)

11.25 in.
(28.5 cm.)
Tension
Roller
Drive
Roller
Tension Roller Catch
Speed Control
Speed Control
Fwd/Rev Switch
Fwd/Rev Switch
XLR Power Connector XLR Power
Connector
BOTTOM VIEW FRONT VIEW
BOTTOM VIEW BACK VIEW
Fan
11.31in. (28.7 cm.)
9.93in. (25.2 cm.)
10.5 in.
(26.6 cm.)
BOTTOM VIEW BOTTOM VIEW
Speed Control
Fwd/Rev Switch
Fan
3.93 in
(7.7 cm)
2 in
(5 cm)
Fan
PROPER
TY OF
GAMPRODUCTS, INC. www
.gamonline.com
400900
Motor
11.31in.
(28.7 cm.)
Page 2 of 2 www.rosco.com
SPEED & DIRECTION
The SX4® has a built-in Forward/Reverse Switch for the occasion when the chosen focus effect works well on one focus
setting but the effect is traveling in the wrong direction. There is also a two-speed control knob that can be used with a
dimmer.
REVERSE SWITCH
The SX4® has a built-in Forward/Reverse Switch for the occasion when the chosen focus effect works well on one focus
setting but the effect is traveling in the wrong direction.
SAFETY LOOP
Attach a safety cable to the safety loop on the bottom of the Effects Drawer and to the yoke or light pipe.
TIPS
• For longest life and for the most effective image, be sure to adjust the centering and flatness of lamp field -
NO HOT SPOT IN THE CENTER
• Hot spots will cause uneven heating and wear on the FX/Loop and shorten their useful life.
• Always have the FX/Loop in motion before the light comes on. Don’t allow the FX/Loop to be still in the gate
with the lamp on as this will allow one section to heat up and will shorten the life of the loop (especially if focused
on the seam).
• Shipping and Storage: To prevent damage to the screws or to the mechanism, be sure the drawer retaining screws
are tightened securely.
XLR CONNECTIONS
• Pin 1 = Common
• Pin 2 = FAN +12v
• Pin 3 = Affects Motor /Speed Control +12v