Power supply information, Power switch – Gamber-Johnson 7160-0526-xx User Manual

Page 4

Advertising
background image

information regarding these features.

*Refer to the Power Supply and Wiring Instructions sections of this manual for further

switch position.

(bypassing the power switch) and the green LED light is lit regardless of

off to regulate power through the unit.

By-Pass Installation - In this set-up, the unit is continuously powered

This docking station has a power switch with an LED light (see Figure 1):

Figure 1

docking station and bypass the power switch.

Standard Installation - In this set-up, the power switch can be turned on and

switch on the docking station, regulating power through the unit.

By-Pass Installation - Use the BLUE and BLACK wires to continuously power the

Power is provided using the wires located on the underside of the docking station:

volt DC system. The voltage output is factory set at 19 volts.

This docking station has a built-in power supply and is designed to be used with an 11 - 28

POWER SUPPLY INFORMATION

Page 4 of 8

POWER SWITCH

Standard Installation - Use the RED and BLACK wires to utilize the power

Power Switch w/
Green "POWER" LED

Red, Black &
Blue Wires w/
Disconnect

"INPUT POWER" - The green LED light, built into the power switch, indicates that there is

power to the unit.

Advertising
This manual is related to the following products: