General Machine Products 70605 Trailer Mounted Fiber Optic Puller - Manual (Page 12)

Page 12 of 24 General Machine Products Co., Inc.
6.0 MAINTENANCE AND SERVICING
It is recommended that this winch is serviced every 12 months, regardless of its con-
dition or the number of operating hours used. This will help to ensure reliable, trouble
free service. It is imperative that any maintenance work is carried out by personnel
suitably trained and qualified to do so.
6.1 PRE-WINCHING MAINTENANCE CHECK
This should be carried out each day prior to the start of winching .
6.1.1
Check the hydraulic oil level. Oil should be visible within the black lines marked on
the hydraulic oil level sight gauge. Replenish if necessary with the correct grade of
hydraulic oil to suit the climatic conditions. (Refer to the section 4 for grades of hy-
draulic oil required).
6.1.2
Check the engine oil level as indicated in the engine manufacturers manual. Replen-
ish if necessary.
6.1.3
Check that there is enough fuel in the tank to complete the planned winching sched-
ule.
6.1.4
Check the condition of the hydraulic hoses, replace if damaged.
6.1.5
Check the condition of the pulling rope, particularly where it joins the drum. Only use
a good condition rope of suitable pulling capacity
6.1.6
Check that all screw fasteners are tight.
6.1.7
Check the hydraulic oil system for leaks, rectify before proceeding.
6.1.8
Clean any dirt or debris from the take-up drum shaft and capstan face.