General Machine Products 70601 Adams CD Lite Winch - Manual (Page 17)

right side) and the wire rope is spooled onto the winch drum at the bottom. As with any winch, it is im-
perative that the wire rope be attached to the correct side of the drum for the specific direction of the lay
of the rope given the direction of drum rotation. When the drum will be underwinding as the wire rope
is spooled in, use the rope clamp on the side of the drum which is opposite of the lay of the wire rope.
For example, if using right lay rope on an underwind drum attach the wire rope to the left side rope clamp.
For the underwind application, the wire rope must have unrestricted travel from the tail shelf sheave to
the winch drum. Be certain that the wire rope will be able to freely traverse the entire width of the
drum. Application engineering assistance is available from the factory.
WARNING! The cable clamp alone is not designed to hold the rated load. Approximately ½ of the
first layer of winch line must be left on the drum to achieve the rated load and avoid
cable clamp failure.
3.08 WINCH IDENTIFICATION - Manufacturer or dealer assistance is available to help resolve
unique problems. When contacting your local dealer or the factory, proper assistance can be offered if
the model and serial number of the winch in question is specified. This information is stamped on a
nameplate affixed to the gearbox or winch frame.
4. PRE-OPERATIONAL CHECKS
IMPORTANT CHECKS TO BE MADE BEFORE PLACING THE WINCH IN SERVICE:
Make certain that the winch assembly is properly secured to the chassis frame.
The operator shall have a complete understanding of all functions and the location and operation of all
controls.
The winch line should be spooled on the drum with tight, even, coils and lays.
It is not necessary to have the drum filled with winch line. Additional pulling capability can be ob-
tained by only installing a slight excess of the maximum length required for the job, while also improv-
ing the laying of winch line on the drum.
Refer to the operating manual for the vehicle for specific operational instructions on the hydraulic sys-
tem.
Check the hydraulic system to make certain that the reservoir is filled to the correct level with the
proper grade of oil.
Make certain that the reservoir shut-off valve is open.
Check the hydraulic system for the correct pressure and flow.
Check all winch and winch accessory gear housings for the correct oil level and grade.
See Section 6.02, LUBRICATION.
Page 16