General Machine Products 70601 Adams CD Lite Winch - Manual (Page 28)

1a. General Machine Products Co., Inc. ("GMP") warrants to the purchaser and/or end
user:
(1) that a new product sold and manufactured by GMP will be free from original defects in
material and workmanship for one year from the date the product was delivered to the
purchaser and/or end user, or for the lifetime of the Modular Plug Presser;
(2) that a new product sold and not manufactured by GMP will be covered exclusively by
the manufacturer's warranty. However, if that warranty coverage shall provide less cover-
age than the GMP Warranty for its manufactured products, then the warranty set forth in
Paragraph 1(a)(1) above shall apply instead;
(3) that a reconditioned used GMP product sold by GMP, or a non-owned product repaired
by GMP, or a new part sold by GMP, will be free from original defects in material and work-
manship for ninety days from the date the product was delivered to the purchaser and/or
end user.
1b. The above warranties are contingent upon and subject to the condition that: (1) the
end user substantiates the date it purchased and received delivery of the product or part,
and (2) the product or part shall have been installed, maintained and used in accordance
with GMP's or the manufacturer's written instructions.
2. The end user shall determine the suitability of GMP's product or part for intended use,
and the end user assumes all risk and liability whatsoever in connection therewith except
to the extent set forth in this Limited Warranty.
3a. GMP reserves the right to request that the product or part be returned to us for exami-
nation and cannot be responsible for user charges incurred in the replacement of any prod-
uct. GMP's agreement to repair or replace is also subject to its inspection of the product
and verification of the defect.
3b. Subject to immediate written notification of a defect or malfunction, GMP will repair or
replace that product or part, at GMP's option, returned freight prepaid to Trevose, PA.
3c. To obtain repair or replacement service under the Limited Warranty, the purchaser
must contact the factory for a Return Material Authorization (RMA). Once obtained, send
the RMA along with the defective part or product, transportation prepaid to:
General Machine Products Co., Inc.
3111 Old Lincoln Highway
Trevose, PA 19053-4996 USA
Tel: 215.357.5500
3d. The field labor and material charges incurred by an authorized GMP dealer or an end
user to disassemble, inspect, repair and reassemble our product or part at their respective
prime locations will not be reimbursed unless GMP has first reviewed and approved those
charges.
3e. Incidental repair charges incurred by an authorized dealer or an end user for items
such as labor, transportation, tolls, lodging and meals at a location remote from its prime
facility, or to demount our product or part from its remote location and forward to its prime
facility, are not the responsibility of GMP, and are not covered by this Warranty.