General Machine Products 70601 Adams CD Lite Winch - Manual (Page 21)

6.03 WINCH IDENTIFICATION - Manufacturer or dealer assistance is available when needed to
assist in resolving unique maintenance problems. When contacting your local dealer or the factory,
proper assistance can be offered if the model and serial number of the winch in question is specified.
This information is stamped on a nameplate affixed to the gearbox.
6.04 CALIPER BRAKE - It is recommended that brake hoses and brake lines be inspected regu-
larly. All damaged or worn parts should be replaced. The reservoir should be checked for brake fluid
level and clean brake fluid added as required.
See Section 3.04 CALIPER BRAKE for Special Instructions on Bleeding.
7. REPLACEMENT PARTS
Replacement parts information can be found on the ensuing pages. If parts other than those illustrated
are required, please contact the factory for specific application engineering support.
Page 20
© General Machine Products Co., Inc. 3111 Old Lincoln Highway, Trevose PA 19053-4996 USA
Tel: 1 215 357 5500 Fax: 1 215 357 6216 e-mail: [email protected] http://www.GMPtools.com