Bissell V. (VERSUSTM ) 76T8 - Manual (Page 5)

5
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Tool required: Phillips screwdriver
1. Slide upper handle onto unit. Insert one screw
into hole and tighten until snug. Screw will
be taped directly above cord wrap on back of
handle.
2. Hose will come assembled and wrapped on unit.
Note: It is important that hose is fully inserted
into base for air to be directed properly to foot
during vacuuming.
3. Wrap power cord around cord wrap.
4. Store crevice tool on back lower left side of
unit by snapping into place. Store the crevice
tool on vacuum as shown.
Foot assembly
No tools are required for assembly.
1. Slide foot pivot into suction path on body of
unit until pivot clicks into place. Ensure
connection is secure.
Transporting your cleaner
Place unit in upright position and tip back to roll
on rear wheels.
Power switch
Power switch is located just below handle on
left side of dirt container. Push switch “ON” (I) to
vacuum, and “OFF” (0) when cleaning is complete.
Handle positions
1. Upright – For storage and above floor
cleaning with crevice tool.
2. Normal cleaning – Lightly press foot of
vacuum and pull handle back to detent.
A
ssembly
Crevice Tool
O
peration
Power Switch
ug110-4049_76T8_408.indd 5 ug110-4049_76T8_408.indd 5 6/5/08 3:24:06 PM 6/5/08 3:24:06 PM