Bissell V. (VERSUSTM ) 76T8 - Manual (Page 8)

8
w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
Clearing clogs
Low suction or poor pickup may be due to a clog
in dirt cup. If this occurs, follow these steps to
check for and clear clog:
1. Unplug unit from electrical outlet. Ensure power
is OFF.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Remove separator grill and check suction inlet
for clog.
5. Grasp hose grip and lift to separate from suction
opening. Check for clog in base or hose.
6. Release twist n’ snap hose from unit by turning
hose to the left. Straighten hose and remove any
clog found.
7. Check foot for clogs in air path.
Brush and wiper maintenance
Regularly check rear angle brush and front
wipers on the underside of unit
to keep clean. Wipe any debris that has
accumulated on the angled brush or front
wipers with a damp cloth.
1. Unsnap rear angled brush by pulling up from
one side. Replace with a new brush by
snapping into track.
2 . To remove wipers, unscrew two tip screws.
Slide old wiper out and insert new wiper.
Note: Any other servicing should be
performed by an authorized service
representative.
M
aintenance and care
Brush
Wipers
ug110-4049_76T8_408.indd 8 ug110-4049_76T8_408.indd 8 6/5/08 3:24:15 PM 6/5/08 3:24:15 PM