Kegerator assembly, Co regulator installation continued, Securing the co tank inside cabinet – Great Northern Popcorn 7976 Frosty Keg Kegerators User Manual
Page 10
3.
The knob may turn by hand, but if needed, use a pair of grips or pliers
to
get it started and then open by hand all the way to the left
).
(
)
4.
Next, attach the regulator to the CO canister as shown in
. Hand tighten
the coupler, then use the wrench provided (see page 5, C) to finish securing the
connection.
When attaching the regulator to the canister, make sure that the gauges
remain upright as show in
. This will ensure that the gauges will be easy to
read when the canister is installed in the cabinet, and that the shut off valves are
easily accessible.
5.
Next, make sure that the CO line washer is installed on the inside of the green
coupler as shown in
. If the washer is not present, remove one of the extra
washers that are attached to the wrench and install as shown.
6.
Next, attach the CO line to the regulator as shown in
. At this point perform
the following checks:
a. Make sure that the red lever on the regulator that leads to the CO line is in the
OFF position, as is shown in
. The lever should be perpendicular to the
line.
b. Make sure that the round red pressure knob is opened all the way to the left and
be sure that the CO tank’s valve is shut so that no gas is flowing.
Figure D
Figure F
Note:
Figure F
Note: When facing the gauges securely installed, note that
the topmost gauge indicates the PSI pressure flowing through the line to the
keg and the left hand gauge
Figure G
Figure H
Figure H
(Figure E
2
2
2
2
2
indicates total tank pressure.
Copyright 2011 DTX International
10
KEGERATOR ASSEMBLY
Co REGULATOR INSTALLATION CONTINUED...
2
Figure F
Figure D
Figure E
Figure G
Figure H
SECURING THE CO TANK INSIDE CABINET
2
1.
Locate the canister strap (page 5, D). Loop the strap onto the back fastener located on
the cabinet interior and place CO tank, with regulator and CO line attached, onto the
back shelf.
CO line is
tightened and that all valves are OFF
2
2
2
2.
Stretch the strap around the tank and hook one end of the strap loop to the foremost
fastener on the cabinet as shown (
).The strap will fit very snugly.
Figure I
3.
Double check that all connections are secure, that the green coupler on the
.
Figure I