Bowflex Elite™ Plus home gym - Manual (Page 12)

Assembly Guide
Figure 12
N
F
O
AA
Figure 11
15
14
16
17
18
Step 11 - Attach the Rollers to the Leg
Extension
Locate the following items:
• From Step 10 - Main Assembly
• Item #14 - Foam Rollers
• Item #15 - Foam Roller End Caps
• Item #16 - Short Chrome Roller Tubes
• Item #17 - Long Chrome Roller Tube
• Item #18 - Roller Tube Spacers
There are (3) Chrome Roller Tubes on the Leg Extension. Place
the Long Chrome Roller Tube (Item #17) through the hole
closest to the Seat.
There are two holes possible in the Leg Extension Pivot Tube
for the lower of the Short Chrome Roller Tubes (Item #16).
Select the correct lower hole for your height - the Roller
should rest on your lower shin above the ankle. Insert the (3)
Chrome Roller Tubes through the holes on the Leg Extension
Pivot Tube and Rear Leg, as shown in Figure 11.
Slide (2) Roller Tube Spacers (Item #18) over each end of the
Long Chrome Roller Tube. Then, slide (2) Foam Rollers (Item
#14) over the ends of all three tubes. Cap the Roller Tubes
with the (6) Foam Roller End Caps (Item #15).
Note: Use a Rubber Mallet to secure the End Caps.
Step 12 - Attach Leg Cable to the Leg
Extension
Locate the following items:
• From Step 11 - Main Assembly
• Item #AA - (1) Leg Cable
• Item #F - (1) 3/8" X 2 1/2" Button Head Screw
• Item #N - (2) 3/8" Washers
• Item #O - (1) 3/8" Nylock Nut
• Item #Q - (1) Bolt Cover
Slide the hooked end of the Leg Cable beneath the Leg
Extension Pulley and into the hole on the Leg Extension Pivot Tube,
as shown in Figure 12.
Place (1) 3/8" Washer (Item #N) over the end of (1) 3/8" X 2
1/2" Button Head Screw (Item #F). Thread the screw through
holes in the Leg Extension and cable end. Place (1) 3/8"
Washer and (1) 3/8" Nylock Nut (Item #O) over the end of the
screw, as shown in Figure 12, and tighten.
Completely tighten hardware installed during
Step 12.
Place (1) Bolt Cover (Item #Q) over the Nylock Nut
installed during Step 12.