Bowflex Elite™ Plus home gym - Manual (Page 18)

A-16
Step 22 - Attach the Bench to the Seat
Assembly
Locate the following items:
• Item #29 - Bench Pad
• From Step 6 - Seat Assembly
The Bench easily attaches and releases from the Seat. To
attach the Bench, insert the half hinge on the end of the
Bench into the half hinge on the seat. To remove the Bench,
lift up on the long portion and pull away from Seat.
Steps 23 through 26 illustrate how to route and
connect the Cables to your new BowFlex
Elite™ Plus
home gym.
Step 23 - Route the Rod Cables
Locate the following items:
• Item #S - (2) Hand Grips
• Item #V - (2) Snap Hooks
• Item #Y - (2) Rod Cables with (2) Snap Hooks (attached)
Un-wrap the Cables from both Pulleys on the Chest bar. Pull
one end of the Cable from the Chest Pulley upwards. Attach
the Cable to one Rod Cap by hooking the Rod Hook through
the hole in the Rod Cap.
Then, fasten one Hand Grip to the Snap Hook on the opposite
end of the Cable, as shown in Figure 23.
Repeat for remaining Chest Pulley Rod Cable.
Figure 22
29
Seat
Assembly
Note: At this time, carefully go over your entire
BowFlex Elite™ Plus home gym, tightening
all screws, nuts and other hardware
securely before exercising on your BowFlex
Elite™ Plus home gym.
Figure 23 - Rod Cables
Hand
Grip
Snap
Hook
Rod
Hook
Rod
Cap
Assembly Guide