iCreation i-700 - Manual (Page 31)

30 31
Intercom
Transferring Calls between Handsets
If you connected more than one handset to a base (you can
connect up to 5 handsets to the same base), you can have a
conversation between two people using two different handsets.
If you have more than one handset registered to the same
base, you can transfer an outside call between the handsets.
Pick up the handset and press . The screen display
shows " " ( is your handset number).
If the called party can answer your call, he/she can press
and start talking. You can see the handset number of
the called party on your screen.
At the end of the conversation, press .
Left
INT x -> x
Press the number of the handset that you want to contact
(from 1 to 5). The called handset starts to ring.
When you are connected to an external call, press
and the number of the handset that you want to contact
If the called party can answer your call, he/she can press
and start talking.
If you want to cancel the transfer before the called party
answers, press
. The call transfer is cancelled.
Left
Left
(from
1 to 5).
1
1
2
2
3
3
4
Paging
Temporary Tone-Dial Switchover
You can page the handset from the base by making the handset
ring with a special ring. It's useful to locate a lost handset or call
the user who currently has the handset.
, briefly press , located on the
base. All handsets registered with the base ring for 15 seconds.
,
press or any keys on the handset.
To send the paging signal
To stop the paging signal before 15 seconds have passed
If you are using pulse dialing because your telephone line
doesn't support tone dialing, you might not be able to access
certain external services (e.g. automatic call centers, voice
mailboxes, interactive telephone systems etc.), because they
need tone dialing. You can avoid this limitation and access them
anyway by doing this:
If a call comes in while the handset is being paged, the
handset stops the paging operation and starts ringing
normally.
Note:
Pick up the handset and press to engage the line.
Press and hold until " " is displayed: your DECT phone
is temporarily in the tone dial mode.
Enter the number of the service that you need to access.
When you hang up, the phone automatically returns to the
pulse mode.
-
1
2
3
4