INFICON UL1000 Helium leak detector Interface description - Manual (Page 10)

1-6
Interface Description
iin
s
70
e1
.fm
Op
er
at
in
g M
a
nua
l
(1
00
4)
:M2 mass 2
:M3 mass 3
:M4 mass 4
:MINVOLume minimum audio volume (0 ... 15)
:MODE mode (HYDROS, AUTO, VAC, SNIFF, SNIFFSP)
:PARTCOUNT Part counting enabled: ON, OFF
:PARTNO Current part number
:PEVACGROSS Pressure switching level: EVAC to GROSS
:PGROSSFINE Pressure switching level: GROSS to FINE
:PROTection protecting functions
:CONTamination <b> contamination protection (ON, OFF)
:CONTLimit contamination protection limit
:EVACtime maximum evacuation time (0 – infinite)
:PARTicle <b> particle protection (ON, OFF)
:PMAX maximum pressure in sniff
:PMIN minimum pressure in sniff
:PURGe <b> Automatic purge: ON, OFF
:RECorder recorder output
:LINK1_2 / 12
:LINK3_4 / 34
off, p1, p2, mant, exp, lr_lin,. Lr_log, p3
:RS232 RS232 mode (ascii, binary)
:SUPPRession Background suppression: OFF, INTERN, INLET
:TESTINGTime
:TESTINGTIMEmax
Maximum testing time for AutoLeakTest
:TESTINGTIMEMIN Minimum testing time for AutoLeakTest
:TIMEAXIS Time axis resolution: AUTO or time in seconds
:TMPVENT TMP vent after power off: ON, OFF
:TRIGger1 trigger 1
:TRIGger2 trigger 2
:UNIT
:LR
leak rate unit (mbar*l/s, Pa*m³/s, atm*cc/s, Torr*l/s,
ppm, g/a, oz/yr)
:Pressure pressure unit (mbar, Pa, atm, Torr)
:VENTdelay vent delay (0, 1, 1.5, 2, NO)
:VOLume
:ZERO
zero (OFF, ON, ULTRA)
*HOUR
:DATE date
:DEVICE operating hours
:POWer time since power on
:RUNup run-up time
:SERVice
:TURBO service turbopump
:FORE service foreline pump
:FILTER service filter
:TIME time
:TURBO operating hours TMP
:TC operating hours frequency converter
*FACtor
:VACuum calibration factor vacuum (selected mass)
:M2 calibration factor vacuum (mass 2)
:M3 calibration factor vacuum (mass 3)
:M4 calibration factor vacuum (mass 4)