INFICON PEG100-D Medium to Ultra-High Vacuum Gauge - Manual (Page 6)

6
tina12e1 (0106) PEG100-D.ga
Attribut ID Access Rule Name Data/Type Description
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
55 (37
hex
) get Serial Number String [5]
56 (38
hex
) get Device Configuration String [8] PEG100-D
57 (38
hex
) get Device Status UNIT Device status
1 = Initialising
2 = Idle (HV on)
4 = Executing (HV on)
58 (3A
hex
) get / set Reporting Mode BYTE Polling, Bit Strobe = 6
COS / Cyclic = 0
60 (3C
hex
) get Exception Status BYTE 0
hex
= ok
1
hex
= HV on, no plasma
2
hex
= HV off
Services
Service Code Name Description
–––––––––––––––––––––––––––––––––––––––––––––––––
14 (0E
hex
) Get Attribute Single
3.3 Assembly Objects (Class Code 04
hex
)
A collection of assembly objects allows the sending of attributes from different application objects in one message
(i.e.: Polling I/O).
3.3.1 Output Assemblies
Messages which a master sends to the PEG100-D.
Output Assembly 1
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
0
res res res res res res HV HV
ON / OFF ON / OFF
Control
3.3.2 Input Assemblies
Messages which the PEG100-D sends to the master.
Input Assembly 2
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
0
res res res res res HV HV Status Sensor
ON / OFF Satus
Source
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
1
Exception Status
2 Pressure value (Low Byte)
3 Pressure value (Low Middle Byte)
4 Pressure value (High Middle Byte)
5 Pressure value (High Byte)