Intelix FLX-8X8A - Manual (Page 12)

FLX-8X8A Installation Guide
12
4. Secure the I/O card by tightening the thumb screws.
5. Connect the appropriate cabling to the I/O card.
6. Power on the matrix.
FLX-BI4 and FLX-BO4 Wiring
A compatible HDBaseT with control transmitter or receiver is required to pass the control signals to the
source or display devices.
To connect the FLX-BI4 to a compatible transmitter or the FLX-BO4 to a compatible receiver, a Cat 5e or
greater cable with a TIA-568B crimp termination on the RJ45 connector must be used. The Cat 5e cable
must not exceed 40 meters for 3D content. The Cat 5e cable must not exceed 70 meters for 2D content.
To use the IR extension capabilities of the FLX-BI4 and FLX-BO4, the DIGIB-EYE (wideband IR receiver)
and DIGIB-EMT (wideband IR emitter) will need to be connected to the appropriate IR ports. These parts
are not included with the HDBaseT I/O cards.
To use the RS232 extension capabilities of the FLX-BI4 and FLX-BO4, connect the TX, ground, and RX
control signal wires to the removable 3-pole terminal block. Consult the manual of the control device(s)
to determine which pins the TX/RX signals are carried on. Be sure to always connect TX to RX and RX to
TX.
TX
RX
GND
RXD (Pin 2)
TXD (Pin 3)
Ground (Pin 5)
Straight-Through RS232 Connection
RXD (Pin 2)
TXD (Pin 3)
Ground (Pin 5)
TX
RX
GND
PC COM Port Controlled Device COM Port FLX-BI4/BO4 3-Pole Euro