IPitomy IP400 Quick Start Guide - Manual (Page 6)

Page 6 of 6
Copyright 2009 © IPitomy Communications, LLC
11. Set Outbound Proxy to Disabled
12. Under Secret, enter the unique Password entered earlier in the IP400 Line Settings page
13. Set Call Limit to equal the number of analog lines connected to the IP400
14. Leave the rest of the fields set to their defaults, or change them in accordance with your
system
15. Click Save Changes
16. Click Apply Changes
Congratulations, your IP400 FXO gateway should now be configured with your PBX, check
Reporting=>Monitoring and you will see it is registered, has an IP address, and the status is OK.
All you need to do at this point is set your incoming and outgoing routing in regards to the IP400
and you will be making and receiving calls using your analog lines.