I.R.I.S. 595 - Manual (Page 7)

7.01 Connecting Up
The fitted power and data cable is provided with bare ends to
aid in installation, so please ensure that care is taken in
identifying the relevant connections and polarity.
Data communications to cameras and other devices is
achieved via a two wire RS485 connection, and the data
connection pins on the controlled devices will be labelled
appropriately with a “+” (positive) and a “–“ (negative)
indicator.
Combinations of multiple control devices and multiple
cameras may be connected together using and Iris Data
Expander.
Power your unit from a dedicated fuse / breaker rated at
12VDC / 500mA. The unit operates when power to the
breaker / fuse is applied. Ensure suitably rated cable is
used to handle the required current and voltage.
Connections from the cable:
7.02 Powering Up
Never apply power to the device unless all connections are
terminated correctly. Never disconnect the DC ground for
any reason whilst the device is powered up as this could
result in damage to the electronic circuitry.
Upon power-up, the controller will perform a brief initialization
sequence that will take a few seconds. An animated
NightRunner logo is displayed in the LCD screen during this
period. After initialization the controller is ready to use.
8.01 Controlling the Camera - Overview
Your camera features positional controls and extended
features. Positional features such as Pan and Tilt are
operated by moving the thumb-stick, whereas Zoom,
Camera Selection and other extended functions are
controlled by pressing the button that corresponds to the
specific feature displayed on the LCD screen.
9.01 Controlling the Camera - IRIS595
This section explains how the camera features are controlled
and selected using the dedicated IRIS595 NightRunner Joystick
Controller.
Below is the IRIS595 HOME Screen:
Camera Select
If you have more than one NightRunner camera connected to
the controller, press the CAM button to enter the Camera Select
screen shown below (default camera = 1).
Select the desired camera (1~8) or move the joystick RIGHT to
access cameras 9~16. Once the desired camera is selected the
controller will return to the HOME screen.
Monitor Select
If you have a video switching matrix on board, use the MON key
to select the desired monitor (default monitor = 1).
Select the desired monitor (1~8) or move the joystick RIGHT to
access monitors 9~16. Once the desired moniitor is selected the
controller will return to the HOME screen.
Switching Between Thermal / Daylight Cameras
Switch between NightRunners two cameras on the IRIS595
controller by selecting either DAY for the daylight camera or
NIGHT for the thermal imaging camera from the home screen.
Zoom Control
Both NightRunner cameras feature digital zoom. From the home
screen on the IRIS595 press IN to increase magnification and
OUT to zoom wide.
Colour Function
Red 12v DC power
Black 0V DC / Ground
Green RS485 Data +
White RS485 Data -