I.R.I.S. 595 - Manual (Page 8)

9.01 Controlling the Camera (Continued...)
MENU
Extended features are accessed by pressing the MENU button.
Please note, in certain menuʼs, camera control functions are
disabled. To exit back to the home screen at any time move the
joystick up. The menu screen is shown below:
Image Flip
If you need to change the image orientation, select the FLIP
option and you will be presented the screen below:
FLIP UP refers to the standard ʻdesktopʼ orientation. The
MIRROR option will flip the image horizontally (useful when
using the camera to look backwards). FLIP DOWN refers to the
camera in the hanging orientation.
Please Note: Vertical FLIP Orientation can be permanently
set via the DIP switches in the base of the camera. See
Section: 10.02 for more details.
Colour
This option inverts the cameras colour palettes. STD (Standard)
displays the default camera image (WHITE HOT for thermal
camera) and NEG displays BLACK HOT for the thermal camera
and Negative image for the Daylight Camera.
Scans
The camera supports 4 different Scan Modes. Once activated,
tilt and zoom commands are still accepted by the camera but
you will not be able to pan the camera until the Scan has been
Stopped:
• 45˚ Auto Scan
! Camera pans back and forth 22.5˚ either side of the
! centre point (the position the camera is facing when the
! scan is activated.
• 90˚ Auto Scan
! Camera pans back and forth 45˚ either side of the
! centre point (the position the camera is facing when the
! scan is activated.
• 180˚ Auto Scan
! Camera pans back and forth 90˚ either side of the
! centre point (the position the camera is facing when the
! scan is activated.
• 360˚ Auto Scan
! Camera pans continuously through 360˚, pausing every
! 108˚.
There are three speed controls for each Scan. Slow, Medium
and Fast.
A command is also available to ʻRe-Centreʼ the scan. This can
be found in the command list.
SET MENU
From the SET menu, user presets and a home position can be
stored and the camera can be sent into Standby Mode and be
told to Wake up from Standby mode.
Standby Mode
From the SET menu, select STNDBY to send the camera into
Standby Mode. This will switch off the video feed and tilt the
camera down so that the lens windows look into the housing
cradle in order to protect the front face of the camera. To
reawaken the camera, select the WAKE key. This switches on
the video and sends the camera to the Home position.