Jabra WAVE - Manual (Page 7)

5
en
g
li
sh
Jabra WaVE
TURNING YOUR HEADSET ON AND OFF
- slide the on/off button towards the symbol “I” to turn the
headset on . When you do so both indicators will flash on the
Jabra statusDisplay™ .
- slide the on/off button towards the symbol “o” to turn the
headset off .
PAIRING IT WITH YOUR PHONE
Headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes .
1 Put the headset in pairing mode
- When you turn on your Jabra WaVE for the first time, the headset
will automatically start up in pairing mode – i .e . it is discoverable
for your phone . When the headset is in pairing mode the Bluetooth®
status indication on the statusDisplay™ is flashing .
2 Set your Bluetooth® phone to ‘discover’ the WAVE
- Follow your phone’s instruction guide . First make sure that
Bluetooth® is activated on your mobile phone . then set your
phone to discover new devices . this usually involves going
to a ‘setup,’ ‘connect’ or ‘bluetooth’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth® device .*
3 Your phone will find the Jabra WAVE
- Your phone will find the headset under name “Jabra WaVE” .
Your phone then asks if you want to pair with the headset .
accept by pressing ‘Yes’ or ‘oK’ on the phone . You may be
asked to confirm with a passkey or PIn . then use 0000 (4
zeros) . Your phone will confirm when pairing is complete and
the Bluetooth® status indication on the statusDisplay™ will
shift from flashing light to steady light and the headset voice
guidance will say “connected” .
* Phone dependent