B&B Electronics Zlinx 485 - Manual (Page 41)

Product Specifications
Manual Documentation Number: Zlinx485m-1808
www.bb-elec.com
www.bb-europe.com
Frequency Input: Two DI inputs per module software selectable as Frequency Counters, 0 to 5 kHz range
(do NOT exceed more than 5kHz)
Digital Outputs
Voltage Range: 10 to 45 VDC (for sourcing outputs), 0 toVDC (for sinking outputs)
Open Source: 40 mA per output
Analog Inputs/Outputs
Ranges: 0 to 10 VDC or 0 to 20 mA
Resolution: 12 bit
Input Accuracy: 0.15 % full scale reading typical, 0.2 % max
Output Accuracy: 0.15 % full scale reading typical, 0.2 % max
AI Load Resistance: 100 Mega ohms when configured for voltage input
250 ohms when configured for current input
AO Max Output Current: 1 mA when configured for voltage output
AO Max Source Load: 375 ohms at 20 mA and 10V input voltage when configured for current output
Input Protection: Over-voltage to 2x max input voltage
Power Supply Voltage
Requirements:
10 VDC to 30 VDC
Power Supply: Not included
Base Module Power Connector: Removable screw terminal (2) block, 3.5 mm spacing
Relay Outputs
Number of Relays: 8
Type: C (normally open and normally closed)
Output Connection: 3.5mm removable terminal block (2 per output)
Common Connectin: 3.5mm removable terminal block (1 per bank of 4 output)
Ratings: 250 VAC @ 8A, 30 VDC @ 5A (maximum per bank of 4 as grouped on the label)
RTD Inputs
Number of RTD: 4
Wire configuration: 2, 3, and 4 wire
Type: PT100*, PT1000*, Cu10**
*Optimized for temperature coefficient of 385
**Optimized for temperature coefficient of 427
Input Connection: 3.5mm removable terminal block (4 per output)
Temperature Range: PT100 = -200 to 650 º C
PT1000 = -200 to 100 º C
Cu10 = -100 to 260 º C