JULABO TW20 Water Baths - Manual (Page 13)

Water Baths
13
5. Safety recommendations
Follow the safety recommendations to prevent damage to persons or property.
Further, the valid safety instructions for working places must be followed.
 ConnOnly connect the unit to a power socket with earthing contact
(PE – protective earth)!
 Operation is permitted with non-flammable liquids only.
 Place the instrument on an even surface on a pad made of non-
inflammable
material.
 Do not stay in the area below the unit.
 Make sure you read and understand all instructions and safety precautions
listed in this manual before installing or operating your unit.
 Never operate the unit without bath fluid in the bath.
 Prevent water from penetrating into the hot bath oil.
 Do not drain the bath fluid while it is hot!
Check the temperature of the bath fluid prior to draining (by
switching the unit on for a short moment for example).
 Never operate damaged or leaking equipment.
 Always turn off the unit and disconnect the mains cable from the power
source before performing any service or maintenance procedures, or
before moving the unit.
 Always empty the bath before moving the unit.
 Never operate equipment with damaged mains power cables.
 Condensation that could appear in and on other units near the water bath
may result in reduced operating safety.
Be careful when setting up and operating the water bath!
 Some parts of the bath cover may become extremely warm during
continuous operation.
When lifting the bath cover, pay attention to hot steam!
 Be careful when touching these parts!
 Use safety glasses!