JULABO TW20 Water Baths - Manual (Page 4)

Operating manual
4
Operating manual
1. Intended use
JULABO water baths have been designed for temperature application to specific fluids in a
bath tank.
JULABO water baths are not conceived for direct temperature application to
food and luxury articles or pharmaceutical and medico-technical products.
Direct temperature application means: Unprotected contact of the object with
the bath medium (bath fluid).
1.1. Description
PID1
 The water baths are operated via the splash-proof keypad. The implemented
microprocessor technology allows to set and to store the setpoint that can be
indicated on the LED temperature display.
 The PID temperature control adapts the heat supplied to the thermal
requirements of the bath.
 The water baths conforms to the relevant requirements specified by
European guidelines.
 The models TW8, TW12, TW20 provide a drain screw and handles for easy
relocation.
2. Operator responsibility – Safety recommendations
The products of JULABO GmbH warrant a safe operation if installation, operation and
maintenance is carried out according to common safety regulations. This section informs you
about potential dangers that may arise from operating the circulator and also mentions the
most important safety precautions
The operator is responsible for the qualification of the personnel operating the units.
 The operator should be constantly informed about the dangers involved with their job
activities as well as preventive actions.
 Make sure all persons expected to carry out operation, installation and maintenance of
the unit read and understand the safety information and operating instructions.