Kifco T45x1320 400,000 - Present Operator Manual - Manual (Page 15)

OPERATION
Choosing the winding speed
6)
User instruction book St3
CYCLE CYCLE
PAUSE PAUSE
ON ON
OFF OFF
V I T
CYCLE CYCLE
PAUSE PAUSE
ON ON
OFF OFF
V I T
0_ 0_ 250 250
0 0
v_ v_ 0 0M M 0_ 0_
18 18
0 0
0 0 23:14 23:14
CYCLE CYCLE
PAUSE PAUSE
ON ON
OFF OFF
CYCLE CYCLE
PAUSE PAUSE
ON ON
OFF OFF
CYCLE CYCLE
PAUSE PAUSE
- The DOSIDIS
0_ 0_ 250 250
0 0
v_ v_ 0 0A A 0_ 0_
20 20
0 0
0 0 22:01 22:01
DOSIDIS EASYDIS
L D
_ V I T
- The ESC
Electronic speed
control
After unwinding the hose appear
Visualization
of the length
unwound
CYCLE
PAUSE
CYCLE
PAUSE
On
off
- The EASYDIS
Without ESC
- The By-pass
- Use of the regulating screw to act on the speed of winding.
FAST
SLOW
SL
W
O
T
FA
S
- Without electronic speed control,
one can adjust the speed some
acting on the lever of by-pass with the help of
the screw of regulating.
- The reading of the speed is made on the tachometer.
Page 11
- The ESC
Electronic speed
control
- The ESC
Electronic speed
control
The unwinding length The unwinding length
1) Press the function button until the speed
appears on the display:
2) Using the and buttons enter the speed required
3) Press to memorize the change of
speed and up to the main
screen position.
4) Press and the hose reel will start working
a small flashing square replace the black rectangle.
1) Press the mode button two time to
blink the speed.
2) Using the and buttons enter the
speed required
The speed is blinking
- The speed is blinking a few seconds after the last adjustment
then it becomes fixed and set in memory.
3) Press the cycle/pause button to start the winding.
When a small square is blinking the winding is going on.
f)
a)
b)
c)