Kinetik Blood Pressure BPM3C - Manual (Page 6)

Putting on the Cuff
a. Place the cuff on bare skin onto the left wrist making sure that the meter
body is on the palm side, centre of the wrist, as in the picture.
b. Place the cuff 1~2cm above the wrist joint.
c. Use your free hand to adjust the tightness of the cuff until it is firm.
d. To ensure the cuff is the correct tightness, no tension should be felt on the
wrist.
5
Setting up your Blood Pressure Monitor
Please put the cuff on the left wrist.
Do not wrap the cuff too tightly, otherwise results will be inaccurate.
The cuff can be detached and cleaned by hand with warm, soapy water.
Rinse thoroughly with cold water and towel dry.
To detach the cuff, carefully pull it away from the monitor body. To reattach,
push the cuff and monitor body together so that the clips lock in place,
ensuring it is the correct way around (the long part of the cuff should be to the
left of the LCD screen).
DO NOT IRON.
a. Once you install the battery or turn off the monitor, it will enter Clock
Mode, and LCD will display time and date by turns. See picture 2&2-1.
b. While the monitor is in Clock Mode, pressing both the “Start” and
“Memory” button simultaneously, a beep is heard and the month will blink
at first. See picture 2-2. Press the button “Start” repeatedly, the day,
hour and minute will blink in turn. While the number is blinking, press
the button“ Memory ” to increase the number. Hold down the button
“Memory”, the number will increase fast.
c. You can turn off the monitor by pressing “Start” button when the minute
is blinking, then the time and date is confirmed.
d. The monitor will turn off automatically after 1 minute of no operation, with
the time and date unchanged.
e. Once you change the batteries, you should re-adjust the time and date.
6
Clock and Data Adjustment
picture 2
picture 2-1
picture 2-2