Kisan Electronics 30W-D - Manual (Page 22)

Page - 21
25LED-D INSTALLATION:
GOLD WING GL-1800
This unit has matching connectors
for the Honda Gold Wing GL-1800.
The inner plastic liner has to be
removed to gain access to the 2-pin
connectors of the LED spoiler.
Plug the unit in-line and attach it
with the Velcro pad supplied.
The accessory input wire MUST BE
connected to supply power to the
unit. The trunk latch-release (18-
pin) connector is a good place to
tap into. The Light Green wire with
Black stripe is s suitable source.
„ Wrap the scotch-lock connector on the wire then tighten it with pliers
„ Insert the small ring of the wire-end fully in to the slot of the scotch-lock
Please Note!
„ Matching connectors are for the original Hondaline spoiler only.
„ If you have aftermarket spoiler, you may have to discard the
connectors and make appropriate connections.
Refer to the Instructions on page 24 for:
„ Programming Tail light Intensity Levels