Kisan Electronics 30W-D - Manual (Page 4)

Page - 3
10W-D INSTALLATION:
When replacing the Tail/ Brake bulb
with tailBlazer, grab only the flange
with your fingers. DO NOT twist the
glass element. The dual contact bulbs
have indexed pins, so the bulb can
only be inserted one way.
If you have twin dual-contact bulbs in
the taillight housing, we recommend
replacing both. 10W-D is available in
twin-pack.
Should there be a need to replace the 10W Halogen
element, pull the bi-pin bulb straight out from the
base. DO NOT wiggle or twist.
The sockets that hold the pins of the G-4 bulb have
beryllium copper fingers to hold the bulb tightly to
overcome vibrations. Therefore it will take some
force to remove the G-4 bulb.
CAUTION! Harley & Triumph
Sockets of some of these models have
been known to be: wired wrong. Test
to make sure that the barrel of the
socket is grounded, and the contacts
are wires as shown here.
AVOID ELECRICAL FIRES!