Kisan Electronics VL-20 - Manual (Page 17)

Page- 15
FAQ:
Q: I am attempting to mount the LP-16 on my license plate and the
mounting holes do not line-up. What do I have to do install?
A: All license plate vectraLIGHT products are designed for the
harmonized standard adopted in the US. Many European and Canadian
plates are different shapes. Since the mounting tabs are hidden behind
the license plate, you can either screw-in the LED array directly on the
bike or use a spacer plate.
Q: I ordered the matt black finish LPB-16 for my bike. I did not get the
backing plate shown in the brochure.
A: The chrome backing plate is supplied with the LPC-16 product, since it
is required for most cruiser style motorcycles. You can request one and
we will ship it at no charge.
Q: I plan to remove the turn signal lamps and the taillight housing for a
smooth, sleek look. Can I use just the LPC-16 for the rear of my bike
since it’s a run-turn-brake combination accessory?
A: We do not recommend the exclusive use of License Plate
vectraLIGHTs as the taillight accessory. It is designed as auxiliary lighting
equipment.
The DOT requirements for the primary lighting for your bike specifies
many factors such as: minimum distance between the right and left turn
signal lamps, minimum light output per lamp, the license plate illumination
requirement etc.
License Plate vectraLIGHTs were not designed to incorporate such
requirements and we make no such statements to that effect. They are
auxiliary lighting accessory to enhance your visibility in traffic.