Kisan Electronics ManualtailBlazer - Manual (Page 11)

Page - 9
100-HD INSTALLATION:
On most models, access
to the brake wire is
possible by removing the
taillight assembly, or
simply by removing the
seat and following the
rear of the taillight
housing for appropriate
brake wire and ground
wire.
For twin bulb type of
taillight arrangements,
there’s typically a “Y” harness before it is split. In order to modulate both
bulbs together, the correct location for the splice is upstream of the “Y”
harness.
Once you have identified the
brake wire and chosen the correct
location to make the splice, cut
and prepare the wire ends as
shown here. If you plan to use the
rubber boot, feed the wires
though first by piercing a small
hole at the tip of the boot.
Next, Insert the wire-ends and screw-in (3) connections as follows:
„ BRAKE INPUT - is for the stripped wire-end that supplies power.
„ OUTPUT to BULBS - is for the stripped wire-end going to the bulbs.
„ GROUND - is for the wire supplied with ring for attaching to chassis.
Use the Velcro to mount the unit in an appropriate location – away from
high heat or direct water spray.