Kisan Electronics ManualtailBlazer - Manual (Page 9)

Page - 7
30W-D INSTALLATION:
When replacing the Tail/ Brake bulb
with tailBlazer, grab only the flange
with your fingers. DO NOT twist the
glass element. The dual contact bulbs
have indexed pins, so the bulb can
only be inserted one way.
If you have twin dual-contact bulbs in
the taillight housing, we recommend
replacing both. 30W-D is available in
twin-pack.
Should there be a need to replace the 20W Halogen
element, pull the bi-pin bulb straight out from the
base. DO NOT wiggle or twist.
The sockets that hold the pins of the G-4 bulb
have beryllium copper fingers to hold the bulb
tightly to overcome vibrations. Therefore it will
take some force to remove the G-4 bulb.
30W-D can be inserted in the
socket with wrong polarity. If you
do not get the bright flash upon
ignition on, remove it and
reinsert it as shown here.