25led-lt installation – Kisan Electronics ManualtailBlazer User Manual
Page 21
Page - 19
25LED-LT INSTALLATION:
BMW K-1200LT
This unit has matching connectors for
the BMW K-1200LT.
The lower cover and the mirror have to
be removed to gain access to the 2-pin
connector of the LED light-bar.
Plug the unit in-line and attach it with the
Velcro pad supplied.
The accessory input wire MUST BE
connected to supply power to the unit.
Accessory input wire needs to be routed for the connection. Feed it
through the opening towards the back of the passenger backrest. The
Green wire for the heating element of the passenger backrest is a suitable
source.
Wrap the scotch-lock connector on the wire then tighten it with pliers
Insert the small ring of the wire-end fully in to the slot of the scotch-lock
Refer to the Instructions on page 24 for:
Programming Tail light Intensity Levels
Please Note!
Matching connectors are for the original BMW spoiler only.
If you have aftermarket spoiler, you may have to use adapters
to make appropriate connections.