Black Box 5000 - Manual (Page 172)

Multiserver 5000
170
V OICE /F AX
If a voice/fax module is installed, this menu offers
the following two options:
Option Description
Reset Resets the selected voice/fax
Channel channel.
Busy Mode Controls how the busyout state of
the channel is determined.
B USY M ODE
This menu offers the following options:
Option Description
System Causes the system to place the
Controlled channel in the busy state upon one
of the following conditions:
• Composite sync loss lasting more
than forty seconds
• A channel is not connected by the
Switching Control Menu
Forced On Forces the channel into the busy
state, overriding any other existing
condition. Use this option to disable
a defective channel until it can be
repaired.
Forced Off Prevents the channel from going
into a busy state. Primarily used for
test purposes.
L OCAL N ODE N UMBER AND ID
This selection is for configuring the local node
number and ID of the local Multiserver.
Node Node numbers may be 1 through
Number 254. The number must be three
Syntax digits. For example, the number 1 is
input as 001.
Node ID A node ID may be one to eight
Syntax characters in length. Only
alphanumeric characters (A-Z, 0-9),
and the underscore (_) symbol can
be used. The node ID must begin
with a letter (no numbers or
underscores) and must not contain
any spaces (even though the space
appears as a selection).
Once the procedure is started, you must continue
until it is complete. There is no stopping point.
Important
If you press the up arrow during any of
the following steps, the procedure will be
aborted with no changes made. You will
have to start over from the beginning.
Menu Functions
Administration
System
Voice/Fax
Local Node ID
Node number: [240]
EXE
Move cursor one column to the left
Do not use
Increment number by one (if key is held,
the character will increment rapidly)
Move cursor one column to the right
Accepts the new node number