Black Box 5000 - Manual (Page 37)

CHAPTER 4: Base-Unit Installation
35
4.2 CommPak Cartridge Installation and
Removal
I NSTALLING THE C OMM P AK C ARTRIDGE
The CommPak cartridge contains the operating
software for the Multiserver. When a cartridge is not
being used, it should be stored in an anti-static bag.
It is assumed that the CCM is installed. You cannot
install the CommPak cartridge unless the CCM is
installed.
Warning!
Any time that a CommPak is installed
or removed from the base unit, be sure
that the power cord is unplugged.
Failure to do so could result in damage
to the CommPak cartridge.
R EMOVING THE C OMM P AK C ARTRIDGE
If you ever need to remove the CommPak cartridge
(such as for upgrading purposes), these are the
steps you should follow:
1. Unplug the power card from the ac power
socket.
2. Pull out the right side of the extractor handle.
3. Slide out the cartridge. The door will close
behind it.
4.3 Power Up the Unit
After the CommPak cartridge is installed in the
unit, plug the power cord into the back of the unit
and into the wall outlet. The Multiserver will power
up and automatically go into a self-test mode
(which lasts approximately 30 seconds).
4.4 LCD Display
MUL TISER VER 5000
EXE
MUL TISER VER 5000
EXE
Figure 4-2. Step one: Slide the CommPak
cartridge into the bottom beveled door.
The door will move out of the way.
(Do not use the top slot.)
Figure 4-3. Step two: Be sure to push in the
cartridge until it is flush against the
unit. To fully seat the CommPak
cartridge, you will need to exert
pressure. There must be no gap
between the cartridge and the unit.
MUL TISER VER 5000
EXE
Figure 4-4. Pull out the extractor handle in order
to remove the CommPak cartridge.
Figure 4-5. Plug in the power cord after the
CommPak is installed.