KV2 Audio EPAK2500 - Manual (Page 11)

Page | 11
Using the subwoofer insert
The subwoofer insert point gives you the ability to ‘insert’ a signal processing device into the ES
subwoofer signal chain. For instance in some instances it may be necessary to ‘delay’ the signal going
to the subwoofer using a delay line. The Main Input is used as the system input, as per Normal Mode,
but the subwoofer insert switch is switched to ‘Engage’. A feed is taken to the delay line from the
‘Pre Control Out’ connector and the return from the delay line is connected to the ‘Mid/Hi In’ connec-
tor as per the diagram:
Using the System
OUT IN
MID/HIGH SUBWOOFER
OUT IN
CAUTION
AVIS:
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
WARNING:
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING: THIS SURFACE MAY REACH HIGH TEMPERATURE DURING STANDARD USE.
TO ENSURE PROPER OPERATION ALLOW A MINIMUM OF 6 INS. OF CLEARANCE FROM
THIS SURFACE AND ADEQUATE VENTILATION. TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE THIS PANEL OR ANY ATTACHED COMPONENT. NO OPERATOR SERVICE–
ABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL. TO REDUCE THE RISK
OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
SERIAL NUMBER
DESIGNED BY KV2 AUDIO, MANUFACTURED IN THE EUROPEAN UNION, WWW.KV2AUDIO.COM
MID / HIGH SUBWOOFER
ES SERIES SUBS ES 1.0
IN OUT
SUBWOOFER
INSERT
ENGAGE
DISENGAGE
1
0
EPAK2500 lower panel
Device connected into subwoofer insert
EPAK2500 Dimensions