KV2 Audio EPAK2500 - Manual (Page 6)

Unpacking
Unpack the EPAK2500 and check to see if
there is any damage to it. If you find any
damage notify your supplier immediately. Only
the consignee may institute a claim with the
carrier for any damage incurred during ship-
ping. Be sure to save the carton and all packa-
ging materials for the carrier’s inspection.
Should you ever need to ship the unit, only
use the original factory packaging. If the
shipping carton is unavailable, contact your
supplier to obtain a replacement.
The EPAK2500 carton should contain:
s
Mounting
For additional reliability, the amplifier unit is
mounted on a suspension system that isolates
it from the shocks and impacts typically
encountered on the road. For installations, use
the EPAK2500 Wall mounting kit -
+66
AC Power requirements
The EPAK2500 USES
connector. The device must be connected to a
suitable mains socket outlet with protective
earthing connection.
Getting started
AUTION
!
Voltage requirements
Your EPAK2500 will be supplied pre set to the
voltage used in your area. The table below
provides typical current draw figures for the
EPAK2500.
Cooling
The EPAK2500 has a comprehensive passive
cooling system with demand-sensitive forced
cooling back-up, speed controlled fans.
This means that the cooling system never
DRIVES
It is important to have an adequate air supply
around the amplifier allow the cooling air to
flow. Do not expose amplifier heatsing to the
direct sunlight.
If the heat sink gets too hot, its sensing circuit
will open the output relay, disconnecting the
load.
CAUTION:
If the On LED does not illuminate
or the system does not respond to
AUDIO
!
CAUTION
Page | 
CAUTION:
4HE
!
CAUTION
AC Input
Current draw with
amplifier running at
Average Power
Current draw with
amplifier running at
Peak Power
250V 8.25A 12.5A
230V 9A 14A
115V 18A 28A