KV2 Audio EPAK2500 - Manual (Page 13)

EPAK2500 Specifications
Page | 13
High Frequency Amplifier Specification
Type Class AB Push-Pull low inter-modulation Mosfet design
with transformer balanced output
Rated Continuous Power 100W
Distortion <0.05%
Operating Bandwidth 2.5kHz ÷ 28kHz
Mid Frequency Amplifier Specification
Type Class AB Push-Pull low inter-modulation Mosfet
design with transformer balanced output
Rated Continuous Power 200W
Distortion <0.05%
Operating Bandwidth 500Hz ÷ 2.5kHz
Mid-Bass Frequency Amplifier Specification
Type High efficiency, Low frequency, Current-enhancing
switch mode
Rated Continuous Power 600W
Distortion <0.05%
Operating Bandwidth 130Hz ÷ 500Hz
Low Frequency Amplifier Specification
Type High efficiency, Low frequency, Current-enhancing
switch mode
Rated Continuous Power 1600W
Distortion <0.05%
Operating Bandwidth 20Hz ÷ 130Hz
Speaker Input
Speaker Input EP6 (Mid-Hi), EP4 (Sub)
Signal Input
Input Sensitivity 1.0V RMS
Input Impedance 20kΩ
Power Requirements
Power Connector Neutrik PowerCon®
Operating Voltage 100÷120V@60Hz | 205÷240V@50Hz |
225÷260V@50Hz
Recommended Amperage 20A 115V | 10A 230V | 10A 250V
Physical Dimensions
Height 700mm (27.55")
Width 450mm (17.71")
Depth 290mm (11.41")
Weight 32kg (70.4lbs)