Landoll 4K647 FLAIR SHREDDER V-BELT - Manual

4K647
V-BELT INSTALLATION FOR FLAIR SHREDDER
TO CHECK PULLEY ALIGNMENT
Straight Edge
Lay straight edge against both pulleys. Straight edge should touch on
both edges of each pulley. It may be necessary to slide the pulley in
or out of the shaft, as well as move the gearbox to properly align the
belts.
It is important to maintain pulley alignment for normal belt life.
TO CHECK PROPER BELT TENSION ON MODELS
WITH MULTIPLE “C” SECTION BELTS
1-1/4
Force
1. Using spring scale at right angles to the center of the span, apply a force
to one belt large enough to deflect the belt 1-1/4”.
2. The force required should be about 20 lbs. For a new belt that is being
tightened for the first time the force required for 1-1/4” deflection should be
30 lbs.
3. At the end of 2 - 4 hours of operation the should be retightened to the
normal tension.
4. After 24 - 48 hours the belt tension should be rechecked. Either too high
or too low a belt tension will shorten belt life.