Leica Biosystems CW4000 Quick Start Guide - Manual (Page 16)

Page 12 Leica CW4000 Quick Start Guide
Introduction
If you have just received a new image analysis workstation from
Leica, the appropriate software will have already been installed and
configured. This configuration will enable the applications that you
are licensed to use to operate in a fully functional manner; please do
not change this configuration.
This CD, along with the Leica Q550 Servers CD contains all the
software that you need to run the Leica range of cytogenetics
application solutions. These instructions outline the actions needed
to re-install the software or to upgrade an existing system.
If you are installing Leica DC cameras you also need the Leica DC
Camera CD.
WARNING: The installation of Leica Servers and Leica PC interface cards
is a task that should only be undertaken by, or under the direct instruction
of, trained Leica personnel. Installing incorrect options can cause
significant problems that may be difficult to rectify.
Note: Interfering with the factory-set Server options may invalidate the
warranty.
Note: If you choose to uninstall an existing installation, you may lose data
that you have saved, we recommend that you save the current
configuration before making any changes to the installation. See the
section ‘Save Peripheral Settings’.
Note: If you have a Leica Microscope or Image Acquisition peripheral
connected to your PC, then you must install the ‘Leica Q550 Server CD’
before you install this CD.