Lenze EEPM1RA EPM - Manual (Page 20)

 ENGLISH
Operation
4.14 Contrast setting
With this function, you can adjust the viewing angle for the EPM Programmer display.
Press The display shows... Explanation
.
ON
DISPLAY CONTRAST Press the key until the menu appears in the display.
.
ENTER
CONTRAST MEDIUM The currently set value is indicated (e.g. MEDIUM). .
.
ENTER
CONTRAST MEDIU M The cursor is blinking in the display on the right.
. CONTRAST XXXXX Select the setting wanted:
CONTRAST LOW
CONTRAST MEDIUM
CONTRAST HIGH
.
ENTER
CONTRAST LOW The setting selected (e.g. LOW) is accepted. The
cursor stops blinking.
.
MENU
DISPLAY CONTRAST Returns to the main menu..
4.15 Display status messages
With this function, you can set the Programmer’s password and view other important information.
Press The display shows... Explanation
.
MENU
MISCELLANEOUS Press the key until the menu appears in the display.
.
ENTER
S /W VERSION X.XX Takes you to the submenu. The software version
(e.g. 1.00) of the EPM programmer is displayed.
. With the you can select the status messages.
. INTERN CFG 400 Shows the parameter version that the EPM
programmer is configured for (e.g.400).
. F ILES: 1 Indicates the number of parameter files saved in the
EPM programmer.
. B ATTERY: 5.8VDC Displays the current voltage level of the 4 internal
batteries. To guarantee safe operation, the battery
voltage must not fall below 3.6 VDC.
. P ASSWORD: 0000 Displays the set password for the access protection
(Lenze setting: 0000), entering and changing the
password is described in the next section.
.
MENU
MISCELLANEOUS Returns to the main menu.