Lenze E94AYCEO - Manual (Page 39)

6 Commissioning
6.3 Setting the IP configuration of the Servo Drive 9400
39
Lenze · E94AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 12/2013 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2. A double-click on an EtherNet/IP node opens the Configure nodes dialog window.
Here you can set the IP parameters.
3. Click on Transferred.
• The IP configuration is transferred to the corresponding EtherNet/IP node.
• The communication module carries out a stack reset.
• The IP parameters are written to codes
C13000 / C14000 (IP address), C13001 / C14001
(subnet mask) und C13002 / C14002 (gateway address).
• Code C13005 / C14005 (IP configuration reference) is set to ’0: Saved address’ to ensure
that the address transferred can be used.

Tip!
Check whether the configuration has been transferred successfully.
For this purpose, open the Assign IP addresses dialog window (see step 1) and click on the
Find device button.